Expand my Community achievements bar.

SOLVED

Analysis Workspace Visualization Data Source Settings "Lock Selection" Disabled

Avatar

Level 5

My table has six columns but I only want two of them in the visualization, but when I bring up Data Source Settings the "Lock Selection" checkbox is grayed out?

1838019_pastedImage_1.png

1 Accepted Solution

Avatar

Correct answer by
Level 5

Rather than selecting the metric, select the sparkline immediately below it.  After taking that action the option to lock selection should return.

Similar to most platforms you may select non consecutive items by using the ctrl key.

View solution in original post

5 Replies

Avatar

Correct answer by
Level 5

Rather than selecting the metric, select the sparkline immediately below it.  After taking that action the option to lock selection should return.

Similar to most platforms you may select non consecutive items by using the ctrl key.

Avatar

Level 1
didn't understood your answer. Can you expalin again, i m facing the same issue

Avatar

Level 5

Thanks for the tip. That works!

I can now check the box and chose "Selected Positions" from the list. "Selected Items" is still grayed out. What is that for?

Ali

Avatar

Level 5

Lets say you had a list of pages in your rows.  And you wanted to always viz values for the home page.  If you chose 'selected items' it would always render a viz based on that value of the dimension. 

If you selected position in that circumstance it would always return the value in that position (say third row), regardless of if the variable value in that position changes over time.