thanks Barry. I was fortunate that there was already an existing reference for the view part of the report--however because there was that, I didn't even think about using an exists filter.  I should have known. Thanks so much! -skye

thanks Galen, just used this in one of my reports and (typical--for us) had to add on in the following manner because we were doing several sets of filters. But -- it does work even on multiple sets. Very nice. <field>_Mod=notblankAND:1:<field>=<value>AND:1:<field>_Mod=notin OR:1:<field>_Mod=notblan...

Is there any text mode for filtering for a custom form in a template report if your users are using multiple custom forms? In a project report, it would be this: objectCategoriesMM:ID=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxobjectCategoriesMM:ID_Mod=in (i.e. filter on Categories ID) In a template report there'...

Kristine: You should just put the same field (not the calculated field) in the project custom form. When you convert it to the project using a template with that custom form, all the information should carry over. -skye

Kristine: You can't pull information from an existing request's custom form into a project custom form as far as I know. You can do a one-time copy--when you convert a request to a project it will pull the request information over at that point, but that's about it. -skye

I would first advise you to change your support bookmark from support.workfront.com to experience.workfront.com -- they don't update their old support site so while this info is probably good, some of the other sections might not be good moving forward. The screenshot that you gave us looks like the...

hi Jordyn, could you expose the Task Constraint information on each task for me to take a peek at? -skye

nevermind, I think I got it but it's horrible. I was hoping (and thought I remembered reading) that it would be as easy as adding ampersands or pipe symbols [e.g. IF(CONTAINS("status1"&&"status2",{status}... ] but it basically ended up being exactly what I was afraid of: IF(CONTAINS("status1",{statu...

hi folks, this partial code snippet has been shared a lot and it works really well for one status (i.e. task status = complete) , but if I want to add a few statuses, what's the best way to do that? I thought I read something in the community about it a few months ago, but can't figure out the searc...

hi! Yes, we're past this obstacle. We had Fusion and we were having issues with getting permission from IT to connect to AD, because the AD card in Fusion was a 2-way write (would allow us to write to AD). We had Workfront change the card to a read-only so that we can confirm to IT that we will not ...