When viewing a Scenario history, when looking at a Filter inspector such as the one pictured here, there are some filter criteria that appear with a green check. There are some with a gray "circled dot" and others with a red slashed circle, such those shown in Bundle 4 of the picture. What is the d...

Cool solution @Lawson02 . Now to see if I can apply this to my use case. Thanks!

OP again with an update. I received excellent support from Adobe's @yashpandey who provided me with precisely the solution I was looking for, and I want to share it.  Earlier, I had missed an Advanced Setting in the Data Store - Search module, a set of radio buttons labeled "Continue the execution o...

Hi @lgaertner - would you kindly assist with a bit more guidance again? I am trying to turn the complex array in my original post into a simple one and am not meeting with success when I try to follow along with the documentation online.  Here is the basic structure I set up. (Hope the module names ...

Wow. Thank you. I'll do that! Super helpful!  

Hi. Sorry. Me again. I had an array that looked like this (output of an execution):  And in my filter, the condition was intended to allow scenario to continue if "Array does not contain (case-insensitive)"... the 2nd value shown in the array "GO40290". But from this pic, you can see by the green ch...

OP again. I came up with something that worked. Instead of searching the DataStore and using NO output as the condition to continue, I searched the DataStore first for all records and then compiled all of them into an array. I could then could use a filter condition with Array operators to find out ...

I would like to search a data store, and if the search turns up no results, I want to proceed down a specific route downstream of that module (specifically, "there's no record for this already? then let's create one!") However, whenever there is no Output for a search module, the scenario ends and I...

I've asked similar questions in the past. I'm still trying to find ways to keep a scenario from running more than once on the same object. If I have a webhook output that looks like this:is there any way to compare the id of the first bundle with the id of the 2nd bundle before moving onto the next ...

Thank you. You were right.  You know what my mistake was? I was looking at a similar but different form! Appreciate the response!