Hi Glenn,The BAAAM throws "forbidden" when one has entered the incorrect data source or folder ID that does not exist in that particular account itself.Maybe in this case, the folderID you are referring to is either deleted, doesnt exist in this account or it might be the value of anything except the folder ID.Let us know further questions if persist.Thanks,Neetha Tandur

Hi,"Conflict" in BAAAM occurs for a trait, when the trait rule for this trait using some particular data source has already been created.For example: Let's say Trait-A is to be created with trait rule "name = abc" and uses the data source "ABC".And there is already a trait called Trait-B with trait rule "name = abc" and uses the same data source as above - "ABC"In this case, BAAAM throws the error of "Conflict".Note: Two traits can have the same trait rule provided they are created using differe...

Hi, Adding to what Varun rightly explained:1. Firstly the inbound S3 server of the receiver using the S3 credentials of the same is created by the concerned Adobe consultant. 2. The S2S destination has to be setup at the sender’s instance to send the segments to the receiver (done by the consultant) and according to receiver's requirements, the segments will be mapped to this destination.3. The data source has to be set up at the receiver’s instance to receive the segments that are shared by the...

Hi Nancy,Since S3 is more recommended than FTP, ask the concerned Adobe consultant on the project to provide the credentials of S3 bucket if already created for this account. If not, the consultant raises the SKMS ticket for S3 provisioning and eventually the S3 account will be created whose credentials will be shared to the client.Thanks,Neetha Tandur

Hi Anshul,The traits can be moved easily from one folder to another in "Update" tab of the Bulk Management tool. The only required parameters/columns here are the Trait ids (which traits have to be moved) - sidfolder id (to which folder the traits have to be moved) - folderIdIn the "update" tab of the BAAAM tool, by following the required headers for updation, add the above mentioned columns. Under these columns, add the trait ids and corresponding folderId where the traits have to be moved and ...

Hi Karolina, The traits can be moved easily from one folder to another using "Update" tab of the Bulk Management tool. The only required parameters/columns here are the 1. Trait ids (which traits have to be moved) - sid2. folder id (to which folder the traits have to be moved) - folderId In the "update" tab of the BAAAM sheet, add the above mentioned columns. Under these columns, add the trait ids and corresponding folderId where the traits have to be moved and stored. And the segments are not a...