Move Page to Page 1

[DrDave6]

I'm using LCD 8.2.1

I have a mult-page form that works. When I add a page, the page is added to the bottom of the form and I can then MOVE the page my clicking on the page header in the Hierarchy section and then dragging the page to where I want. Seem to work.

However, if I move the page to page 1 (after the Master Page), I always end up with an extra blank page at the beginning of the document AND I cannot get rid of that extra page. If I MOVE the page to somewhere other than page 1, the blank page disappears.

I only have so much hair left...all suggestions are appreciated.

[Niall_O_Donovan · Accepted solution]

Hi,

It is quite common. I suspect that it is the pagination issue. The original page1 may have been set in the Object > Pagination tab to place on Page1. The new page may have a default pagination set to Follow Previous.

Just go to the pagination for the new page and set it to the master page content, then subsequent pages should be set to Follow Previous. You would only change this is you had multiple Master Pages and wanted to change mid way through the form to a different layout.

Should work then,

Niall

[DrDave6]

That's great, thank you.

Actually, I clicked on the page in question, then went to the Pagination tab in the Object, and set place to "On Page, Page0."

Now I can go wash my remaining hair! Thank you for the quick response.