WCM IO - Label id is shown instead of Label value

[karanmahi]

We have installed the wcm.io package in our AEM instance via inclusion in pom.xml. CA configuration is working fine, except that labels are not shown properly. Instead of a label, it’s showing a label id. I have verified all wcm.io bundles are active in the system/console. I have attached the screenshots below. Any pointers will be appreciated.

[Asutosh_Jena_ · Accepted solution]

Hi @karanmahi 

Can you please provide the AEM version that you are using?

As per the documentation if you are using 6.4+ you should use 1.8.x or more version of io.wcm.caconfig.editor and io.wcm.caconfig.extensions whereas I see that you are using it as 1.6.0 and 1.3.0

Can you please update and try again?

https://wcm.io/caconfig/editor/

https://wcm.io/caconfig/extensions/

Thanks!

[karanmahi]

Hi @Asutosh_Jena_ - We are on 6.5.3. Surprisingly, it's working on local instance but not on development environment. Both local and development environment are on 6.5.3

[Asutosh_Jena_]

@karanmahi 

Can you check if you are getting any kind of error or warning on development environment? Is there any other additional package that is installed on the local instance which is not available on the development environment? Ideally if it is working on local, the same should work on dev as well until unless there is a mismatch in package dependency or missing package.

Could you please share the above info. In the mean time I will also try to replicate the same issue at my end.

Thanks!