Manually enable a scheduled wave | Community
Skip to main content
Y
yusufm786
Level 2
December 19, 2016
Solved

Manually enable a scheduled wave

  • December 19, 2016
  • 2 replies
  • 2114 views

Hi,

If a delivery has been set to go out over a number of waves, once the workflow has run and the delivery sending process is underway, is there any way to then manually enable or push through the following waves?

Thanks

    This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.
    Best answer by vraghav

    Hi yusufm786 ,

    Unfortunately this is not possible. System will be sending out in waves only.

    If you wish to send out the emails immediately

    1. Stop current delivery
    2. Retarget everyone from the original workflow and then perform a split on those who have a successful delivery log for current delivery.
    3. Send the output of split to a new delivery with same content.

    Hope this helps.

    Regards,

    Vipul

    2 replies

    vraghav
    Adobe Employee
    vraghavAdobe EmployeeAccepted solution
    Adobe Employee
    December 20, 2016

    Hi yusufm786 ,

    Unfortunately this is not possible. System will be sending out in waves only.

    If you wish to send out the emails immediately

    1. Stop current delivery
    2. Retarget everyone from the original workflow and then perform a split on those who have a successful delivery log for current delivery.
    3. Send the output of split to a new delivery with same content.

    Hope this helps.

    Regards,

    Vipul

      Y
      yusufm786Author
      Level 2
      December 20, 2016

      Hi Vipul thanks for your reply. Yes I am aware of the method you provided, just thought it would be a useful feature to be able to push waves through manually.

      Thanks again!

      Yusuf

      Terms & ConditionsAccessibility statement

      Loading footer...