Concepts Tab in Fusion | Community
Skip to main content
This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.
Best answer by lgaertner

Hello AAdi,

 

Did you perhaps work with Integromat in the past and imported an old blueprint?

 

As Fusion is based on make.com, which was formerly known as Integromat, this could be an old "feature"...

 

Scenarios that were initiated at least once but were not saved fell into the “Concepts” tab on Integromat. When replicated on Fusion, they will fall to the “Inactive Scenarios” tab.

 

Regards

Lars

1 reply

lgaertner
lgaertnerAccepted solution
Level 9
April 12, 2024

Hello AAdi,

 

Did you perhaps work with Integromat in the past and imported an old blueprint?

 

As Fusion is based on make.com, which was formerly known as Integromat, this could be an old "feature"...

 

Scenarios that were initiated at least once but were not saved fell into the “Concepts” tab on Integromat. When replicated on Fusion, they will fall to the “Inactive Scenarios” tab.

 

Regards

Lars

    S
    SAadi2Author
    Level 3
    April 12, 2024

    @lgaertner Thanks a lot! 🙂 This clears the doubt! 

    Terms & ConditionsAccessibility statement

    Loading footer...