Anyone have projects with 100% completed tasks that will not allow you to set status to complete? | Community
Skip to main content
S
SherrieMatthews
Level 2
May 13, 2021
Question

Anyone have projects with 100% completed tasks that will not allow you to set status to complete?

  • May 13, 2021
  • 4 replies
  • 1995 views

We have a couple of older projects that have all tasks and subtasks complete, but when we go to change the status, it will not switch to complete. Has anyone found a fix to this glitch?

This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.

4 replies

K
KristinaWa1
Level 3
May 13, 2021

Have you looked to see if there are any open issues on the project? That will also prevent it from being able to be changed to a complete status.

S
SherrieMatthewsAuthor
Level 2
May 13, 2021

We did. No open issues associated with this project.

M
MichelleBo3
Level 4
May 13, 2021

Did you try Recalculate Timeline? Sometimes that will work.

S
SherrieMatthewsAuthor
Level 2
May 14, 2021

I was so hopeful, because I had forgotten that trick. But no. Didn't work this time..

Heather_Kulbacki
Community Advisor
Heather_KulbackiCommunity Advisor
Community Advisor
May 14, 2021

In addition to open issues are there any tasks that have a pending approval on them, you might want to create a view for the task list that shows the task status instead of the percent complete.

K
KevinQu1
Level 10
May 14, 2021

This one throws us all the time; created a column on a view to see these quickly.

S
SherrieMatthewsAuthor
Level 2
May 14, 2021

Ooh. As a last attempt, I did a bulk task edit to change them to skipped again. Then recalculated. THAT solved the issue. Editing tasks one by one (and I triple-checked each one) did not work. For some reason, it had to be done by bulk.

Thanks for helping me puzzle this one out.

    Doug_Den_Hoed_AtAppStore
    Community Advisor
    Doug_Den_Hoed_AtAppStoreCommunity Advisor
    Community Advisor
    May 14, 2021

    Well done Sherrie,

    I was about to suggest you try setting Project > ... > Completion Mode = Manual, allowing you to then force the Status to Complete, but see that your bulk edit effectively fixed whatever was registering as an incomplete Task, and in turn, then (assuming it is Completion Mode = Automatic) then rippled up to the Project.

    Save until needed.

    Regards,

    Doug

    Terms & ConditionsAccessibility statement

    Loading footer...