How to send a emial using Campaign v7

[liy30495271]

I am new to Adobe Campaign.Who would like to tell me how to use campaign v7 to send an email in detail?

thank you very much indeed.

[liy30495271]

My boss told me I had to send an email with campaign today, or my weekend would be canceled.

Sad,Sad,Sad........

[florentlb]

Hi,

If your installation is properly configured, you just have to follow these steps: Email channel

You can also find some short videos that should help you: Adobe Campaign Videos

Hope you get your weekend!

Florent

[liy30495271]

Hi,florentlb

Unfortunately, I still failed to achieve the purpose of sending mail.

I'm now learning to deploy the local version of Adobe Campaign Server, and I want to know how to install the configuration so that operators can send mail. Can you tell me more about it?

thanks

Li

[liy30495271]

Hi Florent

thank you for your answer

But,it still can not send the mail,the latest progress shown below

i don't know why the status column always shows pending.Can you help me analyze the reason?

my MTA configuration is shown as follows:

Best Regards

Li

[Adhiyan · Accepted solution]

Hello Li,

Can you please provide me the details below :

Open the delivery which is in start pending> Click on the edit tab on the top left>Click edit source XML.

In the scheduling node , you would find the IPaffinity , can you please check if it corresponds to the ones defined in the config file.

If this matches one of the affinities defined , update the config file with the address as 0.0.0.0 and weight="1" and then perform a nlserver config -reload command to reload the changes and then try sending another email delivery.

Hope this helps.

Adhiyan

[liy30495271]

Hi Adhiyan,

Thank you for your help.

I successfully sent the mail.

Thanks again.

Li

[liy30495271]

Hello Adhiyan,

in accordance with the tips you gave me,i sent the mail successfully,but unfortunately there were other problems.

When i sent the email delivery as the same way,campaign shows that i has been sent successfully,but in fact  it has not

been sent successfully. To intercept request log display,campaign sends a RSET command,the end of the session that initiative failed to send mail

Are there any configurations that limit mail delivery?

phenomenon is as follows:

Regards

Li

[liy30495271]

Hi Adhiyan,

Campaign always reminds me of this warning when i send a mail delivery.

Can you tell me how to eliminate this warning ?The warning reads  'No opt-out link in the text content'.

as follows:

Regards

Li

[florentlb]

Hi Li,

You'd need to add a personalization block to your delivery. There is one by default that allows to add an unsubscription link to the content of the delivery.

Here is how: https://docs.campaign.adobe.com/doc/AC6.1/en/DLV_Personalizing_deliveries_Personalization_blocks.htm...​

Let me know,

Florent