My rule's firing, but my data element won't populate, why? | Adobe Higher Education
Skip to main content
Este tópico foi fechado para respostas.
Melhor resposta por Adobo_Supportus

You'll find the most up to date answer here --> KB Article: My rule’s firing, but my data element won’t populate, why?

 

Reminder- you can always search our Knowledge Base for tips, tricks, and troubleshooting.

2 Respostas

Adobo_Supportus
Adobo_SupportusAutorResposta
Level 7
October 16, 2015

You'll find the most up to date answer here --> KB Article: My rule’s firing, but my data element won’t populate, why?

 

Reminder- you can always search our Knowledge Base for tips, tricks, and troubleshooting.

Rudi_Shumpert
Adobe Employee
Rudi_ShumpertAdobe Employee
Adobe Employee
October 16, 2015

First, check and make sure the data element is setup correctly by following the steps described here 'How do I test if my data element is setup correctly?'.

If the data element is setup correctly, then it is likely a timing issue. Check and see where the rule is loading (in the rule condition); if it’s loading at Top of Page or Onload, then the data element is likely not available on the page yet when the rule fires. Try switching the rule to load at Bottom of Page or DOM Ready so the data element has more time to populate before the rules fires.

If the load order is corrected and the issue persists, make sure the data element is referenced properly in the rule. See this help link for reference -https://microsite.omniture.com/t2/help/en_US/dtm/#Data_Elements

Termos e condiçõesAccessibility statement

Loading footer...