Asset folders, unable to set policies | Community
Skip to main content
R
RobertHarper
Level 3
June 28, 2022

Asset folders, unable to set policies

  • June 28, 2022
  • 2 replies
  • 2583 views

I had an instance that crashed. I was working on content fragments and had set policies to only allow certain content fragment models to be under some folders to organize data. I have stood up a new instance but the policies tab does not show in the folder configurations so I can change which content fragment models may be seen. If I apply a package that had the old settings, clicking on the folder causes errors.

 

What do I need to set to enable the policies tab on folders?

This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.

2 replies

SantoshSai
Community Advisor
SantoshSaiCommunity Advisor
Community Advisor
June 28, 2022

Hi @robertharper ,

Could you please tell us which version of the AEM you are using?

Regards,

Santosh

Santosh Sai
    R
    RobertHarperAuthor
    Level 3
    June 28, 2022

    6.5

    service pack 6.5.11 installed

     

      R
      RobertHarperAuthor
      Level 3
      June 28, 2022

      Hi @robertharper Asset Folder Policies tab and Page Properties Policies tab both are different.

      To check Page Policies, you have to switch to Edit Template from page menu

       

      then edit Page Policy

       

      However, in terms Asset Folder you should be able to see Policies tab under Page properties 

       


      I understand that. I am checking FOLDER properties and the policies tab, where you select if the policies are inherited from the parent and if you are overriding them, which content fragments are allowed. 

        R
        RobertHarperAuthor
        Level 3
        June 28, 2022

        Also, I had an old package with the content fragment definitions in it and there were policy nodes on the folders that specified which content fragments to allow. This doesn't seem to be working because the specified models are not shown when I try to create a new fragment.

          Terms & ConditionsAccessibility statement

          Loading footer...