How to create a trait capturing a blank value of a key-value pair? | Community
Skip to main content
A
akwankl
Level 6
March 17, 2021
Solved

How to create a trait capturing a blank value of a key-value pair?

  • March 17, 2021
  • 2 replies
  • 3259 views

Hi there,

 

Just wondering how do I create an onboarded trait to capture a key-value pair where the value is NULL or empty? I tried doing that but AAM gives me a pop-up that says "The Value cannot be blank" 

 

Thanks!

 

This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.
Best answer by Praupadh

Hi Akwankl,

 

You can create Traits based on Null & NA values but AAM won't allow you to create a blank Trait expression so while onboarding data into AAM make sure instead of onboarding an empty value please use NULL or NA values.

 

Thank You

Prabhat Upadhyay

2 replies

P
Adobe Employee
PraupadhAdobe EmployeeAccepted solution
Adobe Employee
March 17, 2021

Hi Akwankl,

 

You can create Traits based on Null & NA values but AAM won't allow you to create a blank Trait expression so while onboarding data into AAM make sure instead of onboarding an empty value please use NULL or NA values.

 

Thank You

Prabhat Upadhyay

Ankita_Sodhi
Adobe Employee
Ankita_SodhiAdobe Employee
Adobe Employee
April 2, 2021

Hello There,

 

You need to create the onboarded traits prior to sending data files into AAM otherwise all of the new signals will be lost. As you correctly said, to perform backfilling of those new signals there will be an additional cost.

S
Adobe Employee
shweta_singhAdobe Employee
Adobe Employee
March 17, 2021

Hi @akwankl ,

 

You can use below mentioned steps to create trait which capture null value.

1.In the UI, create a trait with signal = “value”, in the expression builder;  
2.Save the trait;  
3.Edit the trait;  
4.Go to trait expression -> code view;  
5.Remove “value” and replace it with “”;  
6.Save the trait without going back to the expression builder;  
7.You'll see an error message: The Value cannot be blank. Press OK to dismiss it.

 

Regards,

Shweta

A
akwanklAuthor
Level 6
March 17, 2021

Hi @shweta_singh 

 
This is an interesting workaround. I tried it and now whenever I visit this trait page the "Value cannot be blank" always pops up. I also don't see the key="" in the trait expression, is this the expected behaviour?
 
Thanks!
Terms & ConditionsAccessibility statement

Loading footer...