Wired Form Functionality | Community
Skip to main content
Ravi_Ansal2
Level 5
August 11, 2015
Solved

Wired Form Functionality

  • August 11, 2015
  • 1 reply
  • 3740 views

Hi There,

I am facing a weird problem with Forms 2.0.

I have three required drop down select box and they all are required. If some body doesn't fills it up then as usual the validation popup comes up but the problem is after that popup i am not able to select that field again. Below is the Screen Shot.

I am not able to select it again and if i go ahead and click on some other field that it works.

Is there any one facing the similar issue.

This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.
Best answer by SanfordWhiteman

You have a CSS rule applying to the validation errors (the red box) that I doubt your designer intended to cascade into the form.  This is affecting your ability to navigate back to the inputs after an error.

SECTION DIV {

    position: relative !important;

    top: 0px !important;

    left: 0px !important;

}

All the DIVs in the Marketo form are SECTION DIVs on your page.  You should figure out something more specific -- try SECTION > DIV instead.

1 reply

SanfordWhiteman
Level 10
August 11, 2015

Please post the actual URL instead of just a screenshot, so I can see the bug in action.

Ravi_Ansal2
Level 5
August 11, 2015

Here You go Sanford:

Best Practices: Modeling Complex Products

Try selecting that field after the POP up before clicking on any other Field.

SanfordWhiteman
SanfordWhitemanAccepted solution
Level 10
August 11, 2015

You have a CSS rule applying to the validation errors (the red box) that I doubt your designer intended to cascade into the form.  This is affecting your ability to navigate back to the inputs after an error.

SECTION DIV {

    position: relative !important;

    top: 0px !important;

    left: 0px !important;

}

All the DIVs in the Marketo form are SECTION DIVs on your page.  You should figure out something more specific -- try SECTION > DIV instead.