GoToWebinar Event Invite | Community
Skip to main content
Sherry_Hale
Sherry_Hale
Level 4
November 25, 2014
Question

GoToWebinar Event Invite

  • November 25, 2014
  • 7 replies
  • 2906 views
Good morning,

I recently switched from WebEx Event center to GotoWebinar and I've reviewed the instructions which appear to be the same but the results were a disaser.  Here is what I read and followed without issue https://community.marketo.com/MarketoArticle?id=kA050000000LOFFCA4

The problem was when I went to invite - instead of inviting, it automatically registered almost 2k people for the webinar.  I was told by support to sync with a campaign in SFDC which I did NOT do with WebEx and am wondering if this is what caused the adding of all invitees rather than inviting them.  

Any ideas on how to make sure this doesn't happen again?
This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.

7 replies

Grant_Booth
Grant_Booth
Level 9
November 25, 2014
Do you know if you were using a different channel for it's program statuses than the last webinar? Also, how was the email sent (smart campaign, email program, etc.)? This should have nothing to do with WebEx v. GoToWebinar. It kind of sounds like maybe the channel had "Registered" as it's first status - which it might default to when the email is sent depending on what sent the email.
Josh_Hill13
Josh_Hill13
Level 10
November 25, 2014
It sounds like you sent the invitation and the Flow step had Program Status = Registered instead of "Sent"

Your Registration flow should listen for the form fill out and then do

Change Program Status = Registered
Send Email "Confirmation"

Fix this by Removing everyone from the Program (or just removing the people who did NOT go through the registration flow properly).
Sherry_Hale
Sherry_HaleAuthor
Level 4
November 25, 2014
Program status was registered but that was step 2 - here is how it was set up:

1 - invitation - send email, change program status to invijted, sync to salesforce
2 -Confirmation - Change program status to Registered (webinar), add to SFDC campaign, interesting moment, sync lead to SFDC, wait 2 hours, create sales task to follow up

That's it - the only difference was on the event level under setup, support told me to add a SFDC campaign sync
A
Anonymous
November 25, 2014
Hey Sherry,
Does your webinar channel in Marketo admin section have all the necessary program status, including "invited" "registered" "attended" "did not attend" and "watched on demand"?

And what flow step did you use inside the smart campaign when you sent the invite?

Thanks,
Jessica

 
Grant_Booth
Grant_Booth
Level 9
November 25, 2014
When you say:
"1 - invitation - send email, change program status to invijted, sync to salesforce
2 -Confirmation - Change program status to Registered (webinar), add to SFDC campaign, interesting moment, sync lead to SFDC, wait 2 hours, create sales task to follow up"

Are these two different smart campaigns, or two different flow steps in the same smart campaign?
Sherry_Hale
Sherry_HaleAuthor
Level 4
November 25, 2014
Jessica, the invite was step 1 that I posted above.  Yes, I ahve all of those program status options.

Grant - Those are two separate smart campaigns
A
Anonymous
November 25, 2014
How about in Salesforce, does the campaign type of webinar in salesforce have a status of "invited"?

 
Terms & ConditionsAccessibility statement

Loading footer...