Anomaly Detection infinite loop if don't choose metrics | Community
Skip to main content
Y
yuhui_sparkline
Level 2
October 16, 2015
Solved

Anomaly Detection infinite loop if don't choose metrics

  • October 16, 2015
  • 1 reply
  • 1199 views

There is a bug in Anomaly Detection. Let's say I haven't set it up yet. When I open Anomaly Detection, it prompts me to add metrics. If I choose "Cancel", the metrics selector goes away momentarily, but then it returns again. Pressing "Cancel" repeats the loop.

So upon pressing "Cancel", instead of sending me through an infinite loop, perhaps I could be shown a message that talks about the benefits of Anomaly Detection and the steps for setting it up.

This post is no longer active and is closed to new replies. Need help? Start a new post to ask your question.
Best answer by BrianAu1

Anomaly detection can't run without metrics which is why it forces the user back into the metric selector to choose at least one metric. If you do have at least one active metric selected and then go back to the metric selector it does close out properly if you click cancel in my experience.

I recommend posting your feedback on the user experience enhancements to the Idea Exchange to bring to the attention of Product Management.

http://ideas.omniture.com/

Best,

Brian

1 reply

B
Adobe Employee
BrianAu1Adobe EmployeeAccepted solution
Adobe Employee
October 16, 2015

Anomaly detection can't run without metrics which is why it forces the user back into the metric selector to choose at least one metric. If you do have at least one active metric selected and then go back to the metric selector it does close out properly if you click cancel in my experience.

I recommend posting your feedback on the user experience enhancements to the Idea Exchange to bring to the attention of Product Management.

http://ideas.omniture.com/

Best,

Brian

Terms & ConditionsAccessibility statement

Loading footer...