After a lot of trial and error, I was able to create a Project Report that shows me projects that status changed in the prior two weeks (only start or finish). At this point it appears to be accurate. This is as close as I can get. Ideally I would like to have all status changes but to date I have n...

What I have noticed is that all projects that were started after May are pulling in but any projects prior to that are not. Laura - are you seeing the same trend? Cory

Anthony, I set my filters up the same way but I am still not getting some changes to pull in. There are two changes that should have come in. One I put into Planning yesterday for about an hour to move some tasks around and put it back into Progress. That is not showing. There was also one that was ...

I am having the same issue. i have a few that will populate but not others and can't figure out why.

Can you do this with issues as well? If so, what needs to be changed? I have not been able to make it work with issues.

That wouldnt be it. The columns that disappear should not have a width.

Eric, Looking at your code and screen shot, I am not sure what what columns you are trying to combine. Are you trying to get them all in one column? Are you placing the blank columns in between the colums you are trying to combine? If the code is correct, they should all reside in one column. ...

In reviewing your code, I was able to see what I was missing and was able to get it to work. Thanks again!

Thanks Scott! Let me give it a try. Also thanks for presenting at Leap! You did a great job!

Can you share more than two columns? I have been able to share two but three does not work.