Sender Address Mask

Avatar

Avatar

alistairk161838

Avatar

alistairk161838

alistairk161838

25-08-2016

Hi,

I'd like to configure Adobe Campaign so that all addresses from a specific domain are authorised to send mails (so essentially I want <%= recipient.firstName %>.<%= recipient.lastName %>@domain.com to be authorised to send emails). How do I configure the 'Authorized masks for the sender address' to allow an entire domain rather than defining specific single addresses?

Thanks in advance

Accepted Solutions (1)

Accepted Solutions (1)

Avatar

Avatar

Linda_Stinson

Employee

Avatar

Linda_Stinson

Employee

Linda_Stinson
Employee

06-09-2016

Hi Alistair,

I asked this question on one of our internal Dls and below is the answer that I got. Let me know if this answers your question.

Regards,

Linda

First of all, a client mustn’t alter the deployment wizard configuration except if they are using on premise platform.

By default, techOps configure “*@domain.tld” sender mask, so they can use “xxxxxx@domain.tld” as sender email address.

Note they must have delegated “domain.tld” (or configure it properly if it’s an on premise client) if they want to avoid any issue when sending emails with the domain.

Answers (1)

Answers (1)

Avatar

Avatar

priyal_b

Avatar

priyal_b

priyal_b

02-07-2019

It is possible, we do it everyday. Just need to have the domain in wizard settings as valid sender and you could do any type of personalization before that.

It works like charm.

hope this helps.