Sender Address Mask | Adobe Higher Education
Skip to main content
Level 3
August 25, 2016
해결됨

Sender Address Mask

  • August 25, 2016
  • 2 답변들
  • 4541 조회

Hi,

I'd like to configure Adobe Campaign so that all addresses from a specific domain are authorised to send mails (so essentially I want <%= recipient.firstName %>.<%= recipient.lastName %>@domain.com to be authorised to send emails). How do I configure the 'Authorized masks for the sender address' to allow an entire domain rather than defining specific single addresses?

Thanks in advance

이 주제는 답변이 닫혔습니다.
최고의 답변: Linda_Stinson

Hi Alistair,

I asked this question on one of our internal Dls and below is the answer that I got. Let me know if this answers your question.

Regards,

Linda

First of all, a client mustn’t alter the deployment wizard configuration except if they are using on premise platform.

By default, techOps configure “*@domain.tld” sender mask, so they can use “xxxxxx@domain.tld” as sender email address.

Note they must have delegated “domain.tld” (or configure it properly if it’s an on premise client) if they want to avoid any issue when sending emails with the domain.

2 답변

Linda_Stinson
Adobe Employee
Adobe Employee
September 6, 2016

Hi Alistair,

I asked this question on one of our internal Dls and below is the answer that I got. Let me know if this answers your question.

Regards,

Linda

First of all, a client mustn’t alter the deployment wizard configuration except if they are using on premise platform.

By default, techOps configure “*@domain.tld” sender mask, so they can use “xxxxxx@domain.tld” as sender email address.

Note they must have delegated “domain.tld” (or configure it properly if it’s an on premise client) if they want to avoid any issue when sending emails with the domain.

priyal_b
Level 3
July 2, 2019

It is possible, we do it everyday. Just need to have the domain in wizard settings as valid sender and you could do any type of personalization before that.

It works like charm.

hope this helps.