Expand my Community achievements bar.

SOLVED

Classification Rule Builder

Avatar

Level 8

Hello Adobe Community !

I have a question on classifications Rules.

I was just going to activate a Classification Rule Set on a Conversion variable - I have all set , but I still have one question on my rule set.

I was planning to classify my research bar results, since lots of them look alike. Neverthless, I'm afraid that the results ( or keys as they are called on the Test Rule set) that are Unmatched will disapear from the reports.

Is it possible to partially classify values from a conversion variable, without classifying as Unmatched the other values ?
What happens to those **Unmatched** Values ?

1224202_pastedImage_2.png

Thanks again !

Mario

1 Accepted Solution

Avatar

Correct answer by
Level 8

Hello Adobe Community !

I found a reliable solution based on all your answers !
This is what I did :


Resultats Recherche Classfiés.PNG

This way, I can have all my Research results without any "Unclassified"- and also my classified "group" results on the same report !

Cheers !

View solution in original post

5 Replies

Avatar

Employee Advisor

Hi marion33678522​,

Any variables that are unmatched via Rule Builder (and weren't manually classified via Classification Upload) will show as "None" in the classification report. Note that the values in the "raw" eVar report will still include all values (whether they were classified or not).

If you're unhappy with those values showing as "None" in the classification report, you can set up one additional rule at the bottom of your rule listing, as a catchall. Perhaps classifying it as "Unclassified" or something else. Here's a sample RegEx you could use as that catchall:

(.*)

Hope that helps answer your question! If not, feel free to follow up

- Eric

Avatar

Level 8

Hello Eric, thanks for your contribution,
I though of using the .* regex joker, so all my other values are classified there.

That means than after this i'll only be able to see those values on the "Unclassified" report' or on the Raw report right ?
Or just on the raw report ?

I could just test this but I think that i takes 24 hours to the servers.

Cheers !

Avatar

Employee Advisor

Just want to add, that the catchAll function should be the first one.

The priority is given to bottom rules. (About Rule Priority)

Avatar

Employee Advisor

Hi marion33678522​ - You can actually set the 'catchall rule' to do one of two things:

1 - Set it so it sets all items that it 'catches' to a dummy value, like "Unclassified" as we discussed earlier.

2 - Set it to the raw value in the classified report. You can do this by setting the "To" column for your RegEx Classification to $0.

And GREAT point by hyderziaee​ - you'll want to set the RegEx catchall rule to the first rule, not the last.

Avatar

Correct answer by
Level 8

Hello Adobe Community !

I found a reliable solution based on all your answers !
This is what I did :


Resultats Recherche Classfiés.PNG

This way, I can have all my Research results without any "Unclassified"- and also my classified "group" results on the same report !

Cheers !